Yushin Robot Manual May 2026

Introduction

  • Gripper failing to actuate:

    EOAT Automated Design Tool Manual: Provides instructions for using Yushin’s software to design End-of-Arm Tooling (EOAT). Key Operations and Controller Navigation yushin robot manual

    controllers. These feature a 3D graphical simulator, Lead Through Teaching for easier programming, and multilingual displays. Introduction

    Yushin Robot Manual: An Excerpt from Model YS-7000 "Steward" Series

    Document ID: YSH-M-2147-G Classification: OPERATOR CONFIDENTIAL (Level 2 Clearance Required) Last Revised: October 12, 2037 Gripper failing to actuate: EOAT Automated Design Tool

    Robot Controller and Programming

    1. Powering On/Off: To power on the robot, press the power button on the controller. To power off, press the button again.
    2. Teach Pendant: The teach pendant is a handheld device used to control the robot. It features a joystick, buttons, and a display screen.
    3. Jog Mode: Jog mode allows you to move the robot manually. Use the joystick to control the robot's movement.
    4. Program Mode: Program mode allows you to execute a pre-programmed routine.

    Power Down: Always turn off both electrical and air power before performing any repair or maintenance.