Nokia 130 Rm1035 Usb Driver May 2026

To connect a Nokia 130 (RM-1035) to a computer, you primarily need the Nokia MTK (MediaTek) drivers

2. Before you begin — preparations

1. Use the original or a good-quality micro-USB cable.
2. Install latest Windows updates (Windows 7/8/10/11).
3. Charge the phone to >30% battery.
4. Enable the correct USB mode on phone (if prompted): select “Mass storage” or “PC Suite” where available.
5. Temporarily disable antivirus if it blocks driver installs (re-enable after).

, which can block these older Nokia drivers. Follow these steps to bypass this: nokia 130 rm1035 usb driver

Official Recovery Tool: The Nokia Software Recovery Tool often includes these drivers automatically.  💻 Step 2: Install Drivers on Windows 10/11  To connect a Nokia 130 (RM-1035) to a

• Use Nokia PC Suite (old version 7.1) – it should detect “Nokia 130”.
• Or open a flashing tool like Infinity Best → Check connection → Should show “Phone found: RM-1035”.

Click Next. If Windows warns about an unsigned driver, select Install this driver software anyway. Use the original or a good-quality micro-USB cable

Step 4: Verify Installation

1. Open Device Manager (Right-click Start → Device Manager).
2. Look under:

   Step 2: Disable Driver Signature Enforcement (For Windows 10 & 11)

   Q2: Can I use this driver on Mac or Linux? No. The official driver is only for Windows. On Linux, the phone may work as a mass storage device without extra drivers. On macOS, no official driver exists.