Fife Csp-01 Manual [top] May 2026

The Fife CSP-01 (often referenced alongside the CDP-01 series) is an analog or digital sensor controller designed for precision lateral web guiding in continuous material processing. While the CSP-01 specifically refers to the sensor controller unit, it is frequently integrated into larger Fife web guiding systems used in printing, laminating, and converting. Technical Specifications

Part 1: What is the Fife CSP-01?

Before diving into the manual, you must understand the hardware. The Fife CSP-01 (often referred to as the "CSP-01 Controller") is a microprocessor-based, single-channel digital guide. It acts as the "brain" of the web guide system, receiving signals from a sensor (like a photoelectric or ultrasonic edge detector) and sending correction commands to a drive (like a stepper motor or proportional valve). Fife Csp-01 Manual

Connect the four motor wires to the A+/A– and B+/B– terminals. If using an integrated connector, match A coil pair and B coil pair.
Verify coil pairs with a multimeter (two wires in same coil show low resistance).

Section 1: General Information and Specifications

This section provides the physical dimensions, environmental ratings (e.g., IP54), and electrical requirements. Why it matters: You will reference this to ensure your control cabinet has adequate cooling and clearance. The Fife CSP-01 (often referenced alongside the CDP-01

acts as the central intelligence for web guiding systems, processing signals from sensors to adjust the material position via a motor-driven guide. Connect the four motor wires to the A+/A–